1st 10 problems cars have.
Do-it-yourself options to end them.

Top ten automotive problem-preventing. problem-solving additives from Mega Power Additives. For the Do-It-Yourselfer. And Professional.

Contact Info: )n a smat phone.To aska question. Order by phone items covered. Call me george, rat 512 665 3388

1st of 10 Problems cars can have. Do it yourself options to end them.

Engine Misfiring. Rough Idle

A misfiring engine is usually caused by worn spark plugs, a vacuum leak,  although the issue could also be with the engine control unit, as well. But not likely. Spark plugs should be changed when there is a misfire code and or rough idle. Service the problem away> Yourself...

Service products you just add to fuel and oil from Mega Power, listed as the Mega Power Worn Motor Treatment is a DIY service to clean spark plugs and sensors caused problems as you drive. Also removes carbon, binding residues, and sludge. From injectors, piston, valves, lifters, and oiling gallies. Ends misfire, rough idle tapping, dozens more  operating and mechanical problems - avoiding their costly repair. More >

#2 of 1st of 10 Problems cars can have. Do it yourself options to end them.

2. Dirty Engine Coolant. Over Heating. Leaks

If you’ve driven over 100,000 miles or your car is five years old and you’ve never had your radiator flushed and refilled, you probably have acids ready to eat holes in gaskets, heater cores, and radiator. The sediment will clog your radiator and having your engine and transmission run 400 degrees hotter than they should be. Service and protect the system using the Mega Power Radiator RS3 Service Product >

#3 of 1st of 10 Problems cars can have. Do it yourself options to end them.

3. Leaking Cooling System Parts

Another reason why your vehicle will overheat is leaking coolant. It could be from a hole. But more than likely a seeping Head Gasket or Manifold gasket putting air into the coolant. It expands to a football size and pushes it out the system overflow.

Other coolant leaks come from defective radiator hoses, gaskets, seals, overflow reservoir, water pump - never topping off the overflow reservoir. or another cooling system part, the level gets too low for the coolant to be effective. Service can usually end these problems.  Repair for such runs over $3000. But can be stop chemically>  Mega Power Radiator RS3 Service Product >

#4 of 1st of 10 Problems cars can have. Do it yourself options to end them.

4. Worn Combustion Parts

If there is a leak in your combustion system, such as sticky piston rings that no longer expand to keep gas and combustion above the piston. And by sticky valve permitting combustion escape. worn pistons and valve stems can cause lost compression and your your engine’s performance. Repair for overhaul or a new engine runs $4000 up. The easy fix?: > Mega Power's Worn Motor Treatment.

#5 of 1st of 10 Problems cars can have. Do it yourself options to end them.

5. Malfunctioning Oxygen Sensor

Another thing that can affect your engine’s performance, turn on the check engine light, and/or make your vehicle fail an emissions test is the oxygen sensor. This part will fail after about 80,000 miles to 100,000 miles of driving due to low engine vacuum, sticky valves, a dirty injector and combustion problem. A dirty catalytic converter. These can be easily serviced away - by driving, and an almost zero smog readout after this Mega Power Smog Service Treatment.

6-10 of 1st of 10 Problems cars can have. Do it yourself options to end them.

6. Excess Combustion Pressure - Blowby

Too much heat and pressure in the combustion chamber can make your vehicle’s engine knock. We call this “spark knock,” and it sounds like pinging or knocking metal. Even minor noise is bad but not devastating. Loud engine knocking can signal catastrophic detonation problems. Now a set of additives easily ends it and compression blowby - the smeely fumes emanating from your engine.The solution to try?  The easy fix?: > Mega Power's Worn Motor Treatment.

7. Motor Oil Buildup

The reason why your oil and filter should be changed every 3,000 miles iin city driving, and 6000 miles mostly highway is sludge buildup throughout your engine. This sludge is deposited on the intake valves, and even on the spark plugs among other crucial engine parts.  The easy fix?: > Mega Power's Worn Motor Treatment.

8. Oil Starvation

Two things cause oil starvation: no motor oil or a failing oil pump. If either of these things happens in your engine, the parts will wear against, and grind against each other and fail or of a sudden. Oil pump failure is rare, and more likely sludge choking the pickup scrren or narrowing passage ways - restricting oil flow.  The easy fix?: > Mega Power's Worn Motor Treatment.

9. No Engine Lubrication

Oil starvation from sludge choked oil delivery problems causes this problem. If your engine’s parts are not being lubricated, you never did a real service on your engine oil system such as mega Power's engine treatment. you’ll be in a world of engine hurt very quickly. An un-lubricated engine will as it seizes because the parts become too hot and jam. Not with MC+ in The easy fix?: > Mega Power's Worn Motor Treatment.

10. Lean or Rich Air/Fuel Mixture

To start, your car engine needs air and fuel in the combustion chamber so the spark plugs can ignite it. Too much air in the mixture creates a lean mixture that reduces your engine’s power. Too much fuel in the mixture makes it rich, and this can flood your engine. Common causes are leaks of the hoses - letting air into the combustion cycle. Bad! Find and fix them. Then clean out the motor to raise the vacuum to 22 to 25 inches. How?  The easy fix?: > Mega Power's Worn Motor Treatment.

   The leader is Mega Power Chemical. An inventor of these products.

 Stops friction and acids problems -all of them removes with  The easy fix?: > Mega Power's Worn Motor Treatment. See Demo >>>

Please Note :

Auto repair shop owners using our Mega Power Servicing Program install these products for a $150 labor charge for cars, $350 for diesels - which includes and oil change, anti wear, new oil, filter, and or fluids.  If the product fails to end the problem, the the shop will reduce the repair change by the Service Cost amount.